Page 61

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX Low temperature working In cold conditions the material should not be applied when the substrate and/or air temperature is 5°C and falling. At 5°C static temperature or at 5°C and rising, the application may proceed. High temperature working At ambient temperatures above 35°C, the material should not be used as this may cause premature setting. Curing SewperCoat® Dry Spray is a cement-based repair mortar. In common with all cementitious materials, SewperCoat® Dry Spray must be cured immediately after finishing in accordance with good concrete practice. The use of Concure A99, sprayed on to the surface of the finished SewperCoat® Dry Spray in a continuous film, is recommended. Large areas should be cured as trowelling progresses (0.5 m2 at a time) without waiting for completion of the entire area. In fast drying conditions, supplementary curing with polythene sheeting taped down at the edges must be used. In cold conditions, the finished repair must be protected from freezing. Estimating Supply SewperCoat® Dry Spray is supplied in 20KG Bag. Coverage and yield Approx 2.4 Tonnes per m³ (Approx 8.3L/20KG bag) Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Page 2 49 SewperCoat® is a registered trademark and the ownership of Kerneos, used under license. Limitations SewperCoat® Dry Spray is a protective mortar lining system, care should be taken when considering for use in structural applications. Please contact Parchem Construction Supplies for further information. Do not mix part bags. The product should not be exposed to moving water during application. Exposure to heavy rainfall prior to the final set may result in surface scour. If any doubts arise concerning temperature or substrate conditions, consult your local Parchem sales office. The degree of rebound with any spray applied cementitious product is heavily influenced by the skill and experience of the spray nozzle operator. Overhead applications will produce higher rebound results. Storage As with all hydraulic binders, SewperCoat® Dry Spray must be stored in dry conditions, off the ground. In this case, it will retain its properties for at least 6 months. In many instances, experience has demonstrated that properties are retained for more than one year. SewperCoat® Dry Spray


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above