Page 594

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL INDEX 582 Technical Data Sheet V 1.0 30-08-13 Liquid Nails Direct Stick Remover Adhesive remover Description Liquid Nails Direct Stick Remover is a special, slightly gelled, solvent to aid removal of Polyurethane adhesives. It is available in a 500mL tin. Uses  For removing Selleys Liquid Nails Direct Stick timber flooring adhesives from suitable hard UV or heat cured pre-finished wooden flooring, steel trowels and other tools.  Suitable for wiping over pre-finished flooring during installation so that any surface contamination by these adhesives can be more easily removed at a later time with this remover.  An effective stripper for removing cured Selleys Liquid Nails Direct Stick timber flooring adhesives from metal application tools and woodcutting tools. Features/Advantages  Light gel consistency  Supplied ready to use  Powerful softening of one-part room temperature cured polyurethane adhesives.  Does not damage most hardwearing UV and heat cured coatings on pre-finished timber flooring  Slow evaporating Instructions for Use/Application Instructions  Shake can before opening to ensure the contents are uniform. Wear solvent resistant gloves.  Spread out a tissue trimmed to a size larger than the adhesive smeared area.  Pour or spoon remover onto the centre of the tissue until it is completely soaked and flattened down to be in contact all over the surface. Allow to soak up to 4 hours or overnight.  If possible, cover with an up-turned bowl or similar, to reduce evaporation.  After soaking, lift off the still soaking tissue, and use only the special plastic scraper provided to scrape off the adhesive. Start scraping from an area where there is no adhesive to ensure the scraper edge is flat on the pre-finished timber surface.  Holding scraper hard to the surface, scrape the softened adhesive to lift it off the surface.  Thick films of adhesive may require longer soaking or more than one treatment.  Once all the cured adhesive is scraped off, clean residues of Remover from the surface with a dilute solution of suitable detergent and wipe dry. Technical Data/Properties Contact Selleys before using this data for the setting of specifications. Property Typical Result Shelf Life 24 months Technology Hydrocarbon solvent VOC Important Notes/Limitations  Remover will damage the ability of Selleys Liquid Nails Direct Stick timber flooring adhesives to cure and adhere properly.  Do not contaminate surfaces that will require adhesive to be bonded to it.  Do not allow Remover to run down board joints and damage the adhesive beneath.  Pre-test on surfaces first. This product is only suitable for use on hard UV or heat cured urethane prefinishes. It may damage other finishes.  Remover will damage 1k and 2k urethane timber furniture and flooring finishes. www.selleystrade.com.au Page 1 of 2


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above