Page 585

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX 573 Technical Data/Properties Contact Selleys before using this data for the setting of specifications. Property Typical Result Colour Various Density 1.35 Technology Acrylic Application Temperature 10 – 400C Shelf Life 24 months Working Time 10-20 minutes @ 400C Cure Time 24 hours Tensile Strength 0.9 MPa VOC 10 g/L Important Notes/Limitations  Selleys Point Works Gen II should not be used when the surface temperature during application or curing is 10°C or lower.  Do not use Selleys Point Works Gen II if rain is likely within 2 hours.  Although 2 hours of curing in good weather is sufficient for the product to withstand rain, curing times are extended in cold and wet conditions. Curing times can be reduced by the application of Point Works Gen II Accelerant Spray to the wet material soon after it has been applied.  One 10 litre bucket of Selleys Point Works Gen II covers approximately 22 metres of ridging, provided bedding has been finished vertically or slightly under ridge and free of holes and defects.  The expected working time at 40°C is 10 to 20 minutes before product starts to skin. In hot windy weather Point Works Gen II Retardant Spray may be used to slow down skinning of the product surface in the bucket and on the ridge. Storage Store unopened pails below 300C in a cool dry place away from direct sunlight. Unopened pails can be stored for 24 months from the date of manufacture. Opened pails may skin at the surface. Discard any lumps or skin and remaining product can be used. www.selleystrade.com.au Page 2 of 3


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above