Page 584

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL INDEX 572 Technical Data Sheet V 1.1 28-06-13 Point Works GEN II Flexible roof tile pointing compound Description Selleys Point Works Gen II is a flexible roof pointing compound that qualifies as an Adhesive Mechanical Fastener for hip and ridge tiles in accordance with AS2050-2002 (amended 2005) which requires all ridge and hip tiles to be fastened. It has also passed the fatigue loading for both Cyclonic Conditions C3 and C4 after conditioning by prolonged water saturation as per Australian Standard AS4046.8-2006. It is available in a 10L pail in a range of colours (including Neutral) to match all available roof tiles supplied by CSR, Boral and Bristile. Uses  Selleys Point Works Gen II is a flexible tile pointing compound used to finish (point) ridge and hip tiles. Features/Advantages  Passes fatigue loading conditions of Cyclonic Conditions (C3 and C4) as per Australian Standard AS4046.8- 2006.  Ideal for new roofs and roof repairs  Colour matched to all commercially available roof tiles  Unique skin time indicator that changes colour to indicate when the product has skinned  Forms an incredibly strong and durable bond between the tiles and the ridge.  Flexes with normal roof movement without cracking or breaking away  Sag resistant  Smooth formula makes it easy to mix and apply  Water cleanup. Instructions for Use/Application Instructions The following should only be used as a guide and the installer should apply all Australian Standards, BCA/NZBC requirements, and best practices when pointing roofs with Point Works Gen II.  Before use, Selleys Point Works Gen II may be stirred to attain the desired trowelling consistency. Never add water to restore trowelling ability.  When mixing colour into Selleys Point Works Gen II, place the colour as deep as possible into the centre of the bucket (If using a self-dissolving sachet of oxide wait for two minutes for the bag to dissolve before mixing). Mix with a power driven mixing wand at low speed until the colour becomes consistent throughout.  Keep unused Selleys Point Works Gen II closely covered with the plastic sheet inside the bucket and replace lid firmly. On re-opening, remove plastic sheet and any skin formed around the edges, mix and use as normal.  If the product is left open for any period and a crust has formed, discard the dried crust material (Do not add water). The material below will be satisfactory.  Ensure that bedding is free of all holes and defects and has been finished at least 3mm under the ridge tiles (e.g. rake wet bedding immediately under the ridges with the head of a screw). Ensure the surfaces are clean and free of loose material. (Ensure the edges of ridge tiles are free of powdery bedding mortar.)  Trowel Selleys Point Works Gen II to a thickness of 3 to 5 mm, ensuring that pointing has full contact with the roof tile and under the edge of the ridge tile. Trowel in small runs to ensure a neat clean finish. Regularly mix the product in the bucket to avoid skinning.  Finish Selleys Point Works Gen II to a smooth surface with a wet trowel. Regularly clean trowel with water to ensure a smooth finish. In hot weather Point Works Gen II Retardant Spray may be used to slow down skinning of the product surface in the pail and to aid trowelling. Do not Brush or sponge Selleys Point Works Gen II as this will damage the finished appearance. Sweep down each hip and ridge as pointing is complete to prevent excess product adhering to tiles.  Weepholes must be installed in ridges and may be put in as you go or on completion of the job. www.selleystrade.com.au Page 1 of 3


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above