Page 558

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Construction Adhesive Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. INDEX 546 Page 2 *Manufactured and sold under license from Fosroc International Limited. Fosroc and the Fosroc logo are trade marks of Fosroc International Limited, used under license. *Denotes a trade mark of Fosroc International Limited. Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Wet Stick Method: This method is only suitable if one component is porous. Sheet or board is blocked or nailed into position and held until adhesive has lost all solvent – generally 24 - 36 hours. Permanent or temporary nailing is optional for wall panelling, but flooring requires adequate nailing at all times – follow instructions of the flooring supplier as to nailing required. As a guide use 50 mm x 2.8 mm nails for hardwood joists and 65 mm x 2.8 mm nails for softwood joists. Adequate nailing allows reasonable use of the floor immediately. Dry Stick or Contact Method: After locating panel on wall in correct position, apply firm pressure above adhesive and slide sheet slightly to ensure good transfer of adhesive. Remove panel, or apply two or three loose panel pins to top of panel and hinge it away from wall. Allow adhesive to dry (requires free access of air to allow solvent evaporation) for 10 - 30 minutes then recombine in the exact alignment required. Further movement at this stage may damage adhesive film, substrate or both. Apply pressure above bonded area with narrow roller or hammer and padded wood block. Limitations Not suitable for use with expanded polystyrene, plasticised vinyl, polyethylene and some other plastics. It is advisable to do preliminary trials when bonding any plastic material with any adhesive. Supply Product Code: 900083 300 ml cartridge (10 / carton) Coverage Each 300 ml cartridge will yield approximately 15 metres of 5 mm bead or 4 metres of 10 mm bead. Storage 12 months in unopened container stored in a cool, dry place. Storage life is limited after seal is broken.


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above