Page 540

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL INDEX 528 Page 2 ® 1. Apply a first coat of Vandex BB 75E-Z or Cemelast (3 kg/ m², 1.5 mm, mixing instructions as per Technical Data Sheet Vandex BB 75E-Z or Cemelast), at least 1 cm beyond the Vandex Construction Joint Tape. 2. Immediately place the Vandex Construction Joint Tape in the freshly applied Vandex BB 75E-Z or Cemelast coat. Then, embed both fabric edges in the Vandex BB 75E-Z or Cemelast mix. 3. Overcoat Vandex Construction Joint Tape with a second coat of Vandex BB 75E-Z or Cemelast (2 kg/m², 1 mm) and smooth the surface with damp brush. 4. Finished state: Provide appropriate protection of the tape if required. Cross Section Construction Joint = = Vandex BB75 E-Z (elasticized waterproofing slurry) or Cemelast consumption 1 kg/m (wet mix) Vandex Construction Joint Tape Concrete Construction Joint Tape Joints Tape joints, mitre joints and T-joints are bonded using the flexible waterproofing slurry Vandex BB75 E-Z or Cemelast. At least 20 cm overlap – which is glued with Vandex BB75 E-Z or Cemelast is required in the joint details. The overlapping fabric web must be continuous through all the fitting details. 20 cm overlapping area glue joints with Vandex BB75 E-Z or Cemelast Internal and external corners are pre-cut. The tape joints or overlaps are glued with Construction Joint Tape with overlapping area at least 5 cm. Vandex® Construction Joint Tape


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above