CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. Page 2 433 *Manufactured and sold under license from Fosroc International Limited. Fosroc and the Fosroc logo are trade marks of Fosroc International Limited, used under license. *Denotes a trade mark of Fosroc International Limited. Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Fosroc® Expandafoam External walling and cladding Expandafoam is used as a backing strip for expansion joints, as a gap filler for any open joints prior to application of any cold applied joint sealant and as a readily compressible, low load transfer joint filler in joints surrounding brick infill panel walling Glazing Expandafoam is used as a gap filler and backing strip to support perimeter sealing around frames and sub-frames Internal finishes Expandafoam is used as a gap filler and backing strip to provide support to sealants in partition joints and around work tops, baths and other internal finishes and fittings. Supply Available in the following sizes and roll lengths: Product Code 665120 Expandafoam Rod 6mmx250m roll 665121 Expandafoam Rod 10mmx250m roll 665122 Expandafoam Rod 13mmx100m roll 665123 Expandafoam Rod 15mmx100m roll 665124 Expandafoam Rod 20mmx60m roll 665125 Expandafoam Rod 25mmx50m roll 665126 Expandafoam Rod 30mmx50m roll 665127 Expandafoam Rod 40mmx2m strip 665128 Expandafoam Rod 50mmx2m strip Other sizes may be available upon application. Limitations Expandafoam, as with other foam backing rods, is not suitable for use with hot pour sealants. Applications where joint backing must provide continual support for the joint sealant e.g. water retaining structures or floor joints subject to traffic, Hydrocell, a semi rigid filler should be used.
Technical Dayta Sheet Compedium
To see the actual publication please follow the link above