Page 251

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Page 3 239 Durafloor® FC bond is likely to occur. Intending users should always consult Parchem if there is any doubt as to whether a proposed application may involve conditions other than ‘ordinary’. Such extraordinary conditions include: • Unusually cold condition during curing (<7°C) • Above ambient temperatures of service (35°C) e.g. floors subject to hot water • Severe or unusual chemical attack • Severe or unusual conditions of service beyond the limiting physical and chemical properties of epoxies Care should be taken in selecting colours as some will darken or develop a brown tinge when exposed to sunlight or certain chemicals. This effect is noticeable on white, light coloured and grey systems; on brown, yellow and red epoxies it is less noticeable. Durafloor FC is not recommended for exterior use where it is subject to sunlight or in applications involving prolonged water immersion. Cleaning All tools and equipment should be cleaned immediately after use with Solvent 10. Hardened material can only be removed mechanically. Limitations Durafloor FC should not be applied on to surfaces known to suffer from rising damp or having a relative humidity reading greater than 80%. Refer to Parchem for further advice. Durafloor FC should not be applied at temperatures below 7°C. Durafloor FC is also not recommended for use where it is subject to high concentrations of chicken fat or heat. Refer to Parchem for further information on applications subject to these conditions. Durafloor FC is not recommended as an application over tiles. Supply 414504 - Durafloor FC : 4 litre pack plus colour pack Total pack size: 4 litres 412040 - Durafloor Medium Grit : 20 kg bag Coverage 1st coat: 4 - 6 m²/litre on concrete 2nd coat: 3 - 5 m²/litre : fine grit 2 - 3 m²/litre : medium grit The coverage figures given are theoretical - due to wastage factors and the variety and nature of possible substrates, practical coverage figures will be reduced. Specification Clause Epoxy Floor Coating The designated area shall be surfaced with Durafloor FC, a skid resistant, solvent free, 100% epoxy floor coating. The coating shall be applied in a two coat application to a nominal thickness of 400 microns, strictly in accordance with the manufacturers instructions Shelf Life Durafloor FC has a shelf life of 24 months if kept in a dry place below 35°C in the original, unopened packs. Storage Conditions Store in dry conditions between 10°C and 30°C, away from sources of heat and naked flames in the original, unopened packs. If stored at high temperatures the shelf life may be reduced. Durafloor FC should be protected from frost.


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above