Page 156

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Conbextra EP120 Properties The following results were obtained at a temperature of 23°C unless otherwise stated. Test Method Standard Test Result Density 1700 kg/m³ Cure Time 10°C 23°C 30°C 40°C Compressive Strength (MPa) AS1478.2 2005 1 day 3 days 7 days 28 days 56 days INDEX 144 Page 2 0 5 45 70 80 6 45 75 80 85 19 55 80 85 85 38 68 85 85 85 Indirect Tensile Strength AS1012.2 10-2000 28 days - 10MPa Flexural Strength AS1012.2.11-2000 28 days - 25MPa (Modulus of Rupture) Modulus of Elasticity AS 1012.17-1997 8.4 GPa Thermal Coefficient of Expansion ASTM C531:2000 1.06 x 10-4 mm/mm °C Slant Shear Bond Strength ASTM C882/ C882M:2012 22.3 MPa (bond failure) Creep 28 days @ 2.8MPa ASTM C1181-00 @ 23°C 1.7 x 10-3 cm/cm @ 60°C 2.1 x 10-2 cm/cm Chloride Content EN 1015-17:2000 0.0% Pot Life 10°C 20°C 30°C 6 hours 3 hours 1.5 hours Minimum Thickness Maximum Thickness 10mm 120mm Note: Compressive strengths stated above were measured using cube samples. Test results obtained will vary if testing is carried out to an alternative standard or sample dimensions are used. Refer to the compressive strength testing guide for epoxy grouts document for further information. Flow characteristics The maximum distance of flow is governed by the gap thickness, the head of grout applied and the ambient temperature. The following table gives typical data for flow design. Temperature (°C) Gap Thickness (mm) Hydrostatic head (mm) Maximum Flow Conbextra EP120 5 10 100 600 5 35 100 700 20 10 100 750 20 35 100 2000 30 10 100 950 30 35 100 2500


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above