Page 154

Technical Dayta Sheet Compedium

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Conbextra EP65 Plus Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. *Manufactured and sold under license from Fosroc International Limited. Fosroc and the Fosroc logo are trade marks of Fosroc International Limited, used under license. *Denotes a trade mark of Fosroc International Limited. INDEX 142 Page 3 Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Mixing Pour all the contents of the hardener pack into the base container. Mix the hardener slowly into the base using a slow speed heavy duty mixer such as the Protool MXP 1602 E mixer (product code: TT-621941) or equivalent with the Protool HS2 140 x 600 M14 Helical mixing paddle (product code: TT-614217) or equivalent. For large pours a purpose made grout pump can be used such as a diaphragm pump. Cleaning All tools and equipment should be cleaned immediately after use with Solvent 10. Spillages should be absorbed with sand or sawdust and disposed in accordance with local regulations. Temperature During application Grouting may be carried out without special precautions at ambient temperatures from 5°C to 25°C. Where temperatures exceed 20°C note the pot life will be reduced. Cure temperatures below 15°C will result in slower strength build up; at 5°C cure will stop until the material warms. Exotherm: All epoxy systems will develop a temperature rise on mixing. Its extent will be a function of the volume to surface ratio, the ambient temperature as well as the mass and thermal conductivity of the surrounding materials. In service The cured grouts, which are completely resistant to frost and sub-zero temperatures, are suitable for use up to 55°C. Supply Conbextra EP65 Plus: 14 litre 2 component packs 224460 - Conbextra EP65 Plus (Base) 224470 - Conbextra EP65 Plus (Hardener) Storage Conbextra EP65 Plus has a shelf life of 12 months if kept in dry conditions at 20°C. For further information on any of the above, please consult with your local Parchem sales office.


Technical Dayta Sheet Compedium
To see the actual publication please follow the link above