CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Conbextra HS Properties Test Method Standard Result Compressive Strength AS 1478.2:2005 Tested at 200C Consistency Water INDEX 120 Page 2 Addition 8 hrs MPa 12 hrs MPa 1 Day MPa 7 Days MPa 28 Days MPa Flowable 2.7L 5 20 55 75 95 Fluid 3.0L - 13 40 65 80 AS 1478.2:2005 Tested at 300C Consistency Water Addition 8 hrs MPa 12 hrs MPa 1 Day MPa 7 Days MPa 28 Days MPa Flowable 2.7L 26 40 60 85 95 Fluid 3.0L 20 30 50 70 80 Bond Strength by Pull Off EN 1542:1999 2.6MPa Chloride ion Content EN 1015-17:2000 0.04% Fire Rating EN 13687-1:2002 Class A1 Non-combustible Flexural Strength AS 1012.11 - 2000 1 Day (Modulus of Rupture) 7 Days 28 Days 5.8 MPa 11.4 MPa 13.7 MPa Indirect Tensile Strength AS 1012.10.2000 1 Day 7 Days 28 Days 3.6 MPa 5.1 MPa 7.0 MPa Setting Time AS 1012.18:1996 2.5 hours - initial set 5.0 hours - final set Fresh Wet Density 2350 kg/m³ - depending on consistency used Alkali reactive particles Rapid Mortar Bar Test (RTA T363) Non-reactive Flow Characteristics AS 1478.2:2005 600mm (Flow Trough) Expansion Characteristics AS1478.2-2005 ASTM C1107-91 An expansion of up to 2% overcomes plastic settlement Conforms to expansion in hardened state for drying shrinkage Minimum Thickness Maximum Thickness 10mm 125mm Clarification of property values: The typical properties given above are derived from laboratory testing. Compressive strengths stated above were measured using cube samples. Test results obtained will vary if carried out to an alternative standard or sample dimensions are used. Note: Compressive strengths stated were measured at bottom end water addition. Test Results to ASTM Specification C1107: 2001 Test Method Standard Result Flow Consistency ASTM C1437:2007 128% Setting Time ASTM C191:2008 Initial: Final: 3.6 hours 4.4 hours Plastic Volume Change ASTM C1090:2010 +1.22% Hardened Volume Change ASTM:C827:2010 1 day 3 days 14 days 28 days 56 days 0.25% 0.28% 0.28% 0.28% 0.26% Compressive Strength ASTM C109:2011b 1 day 3 days 7 days 28 days 55.8 MPa 77.4 MPa 83.5 MPa 90.1 MPa Note: All tests were carried out at 25oC ± 2oC until the age of the test. Above test results are independent third party results. Copies of these test results are available on request. The tests were carried out at a water addition rate of 2.7L per 20kg.
Technical Dayta Sheet Compedium
To see the actual publication please follow the link above