CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Important notice A Safety Data Sheet (SDS) and Technical Data Sheet (TDS) are available from the Parchem website or upon request from the nearest Parchem sales office. Read the SDS and TDS carefully prior to use as application or performance data may change from time to time. In emergency, contact any Poisons Information Centre (phone 13 11 26 within Australia) or a doctor for advice. Product disclaimer This Technical Data Sheet (TDS) summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. You should read this TDS carefully and consider the information in the context of how the product will be used, including in conjunction with any other product and the type of surfaces to, and the manner in which, the product will be applied. Our responsibility for products sold is subject to our standard terms and conditions of sale. Parchem does not accept any liability either directly or indirectly for any losses suffered in connection with the use or application of the product whether or not in accordance with any advice, specification, recommendation or information given by it. *Manufactured and sold under license from Fosroc International Limited. Fosroc and the Fosroc logo are trade marks of Fosroc International Limited, used under license. *Denotes a trade mark of Fosroc International Limited. INDEX 114 Page 4 Parchem Construction Supplies Pty Ltd 7 Lucca Road, Wyong NSW 2259 Phone: 1300 737 787 www.parchem.com.au ABN 80 069 961 968 Distributed in New Zealand by: Concrete Plus Ltd 23 Watts Rd, Sockburn 8042 Ph: 03 343 0090 Fosroc® Conbextra C Please refer to the Conbextra Cementitous Grouts Application Guide for further information. This is available from the website or your local Parchem branch. Pumping Where large volumes have to be placed Conbextra C may be pumped. A heavy duty diaphragm pump is recommended for this purpose. Screw feed and piston pumps may also be suitable. Maximum aggregate size for pumping is 0.3 mm. Ensure the selected pump is capable of pumping this size aggregate. Curing On completion of the grouting operation, exposed areas should be thoroughly cured. This should be done by the use of Concure curing membrane and continuous application of water and/or wet hessian. Cleaning Conbextra C should be removed from tools and equipment with clean water immediately after use. Cured material can be removed mechanically. Limitations Low temperature working When the air or contact surface temperatures are 5°C or below on a falling thermometer, warm water (30 - 40°C) is recommended to accelerate strength development. For ambient temperatures below 10°C the formwork should be kept in place for at least 36 hours. Normal precautions for winter working with cementitious materials should then be adopted. High temperature working At ambient temperatures above 35°C cool water (below 20°C) should be used for mixing the grout prior to placement. Estimating Yield Consistency (As 1478.2-2005 Table 184.108.40.206) Yield (Litres of mixed material) Stiff 10.4 Plastic 10.7 Flowable 10.8 Fluid 10.9 Supply Conbextra C and Conbextra Grout Aggregate are available in 20 kg moisture resistant bags. 201040 - Conbextra C 202021 - Conbextra Grout Aggregate Storage Conbextra C has a shelf life of 12 months if kept in a dry store in sealed bags. If stored in high temperature and high humidity locations, the shelf life may be reduced.
Technical Dayta Sheet Compedium
To see the actual publication please follow the link above