CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Conbextra C Properties Test Method Standard Result Compressive Strength AS 1478.2:2005 Consistency Water Addition 1 Day 7 Days 28 Days Stiff 2.6-3.4 45 60 70 Plastic 3.4-3.6 35 50 60 Flowable 3.6-3.9 25 45 55 Fluid 3.9-4.0 20 40 50 Bond Strength by Pull Off EN 1542:1999 2.6MPa Chloride ion Content EN 1015-17:2000 0.04% Fire Rating EN 13687-1:2002 Class A1 Non-Combustible Flexural Strength (Modulus AS 1012.11 - 2000 1 Day of Rupture) 7 Days 28 Days INDEX 112 Page 2 5.0 MPa 9.5 MPa 9.6 MPa Indirect Tensile Strength AS 1012.10.2000 1 Day 7 Days 28 Days 2.7 MPa 4.4 MPa 4.8 MPa Setting Time AS 1012.18:1996 5.5 hours - initial set 7.5 hours - final set Fresh Wet Density 2200 kg/m3 - depending on consistency used Alkali reactive particles Rapid Mortar Bar Test (RTA T363) Non-reactive Flow Characteristics AS 1478.2:2005 25-30 seconds (Flow Cone) Minimum Thickness 10mm Maximum Thickness 100mm Clarification of property values: The typical properties given above are derived from laboratory testing at 230C. Compressive strengths stated above were measured using cube samples. Test results obtained will vary if carried out to an alternative standard or sample dimensions are used. Note: Compressive strengths stated were measured at bottom end water, eg., the 28 day strength of 55 MPa for flowable consistency was obtained at a water addition of 3.6 litres of water per 20kg bag of Conbextra C. Test Results to ASTM Specification C1107: 2001 Test Method Standard Result Flow Consistency ASTM C1437:2007 126% Setting Time ASTM C191:2008 Initial: Final: 4.8 hours 6.0 hours Plastic Volume Change ASTM C1090:2010 +0.57% Hardened Volume Change ASTM:C827:2010 1 day 3 days 14 days 28 days 56 days 0.18% 0.18% 0.21% 0.24% 0.22% Compressive Strength ASTM C109:2011b 1 day 3 days 7 days 28 days 30.7 MPa 49.7 MPa 57.8 MPa 64.0 MPa Note: All tests were carried out at 25oC ± 2oC until the age of the test. All above test results are independent third party results. Copies of these test results are available on request. The tests were carried out at a water addition rate of 3.6L per 20kg.
Technical Dayta Sheet Compedium
To see the actual publication please follow the link above