CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX Page 2 109 Fosroc® Conbextra UW Properties Test Method Standard Result Compressive Strength AS 1478.2:2005 Consistency Water Addition 1 Day 7 Days 28 Days Flowable 4.4 L 25 MPa 44 MPa 53 MPa Bond Strength by Pull Off EN 1542:1999 2.6MPa Chloride ion Content EN 1015-17:2000 0.04% Fire Rating EN 13687-1:2002 Class A1 Non-Combustible Flexural Strength (Modulus AS 1012.11 - 2000 1 Day of Rupture) 7 Days 28 Days 3.4 MPa 7.3 MPa 8.8 MPa Indirect Tensile Strength AS 1012.10.2000 1 Day 7 Days 28 Days 1.7 MPa 3.5 MPa 4.1 MPa Tensile Bond Strength to submerged concrete 2.1 MPa Setting Time AS 1012.18:1996 5.0 hours - initial set 7.5 hours - final set Fresh Wet Density 2050 kg/m³ - depending on consistency used Alkali reactive particles Rapid Mortar Bar Test (RTA T363) Non-reactive Flow Characteristics AS 1478.2:2005 400mm (Flow Trough) Minimum Thickness Above Water Below Water 10mm 10mm Maximum Thickness 80mm 150mm Clarification of property values: The typical properties given above are derived from laboratory testing. Compressive strengths stated above were measured using cube samples. Test results obtained will vary if carried out to an alternative standard or sample dimensions are used. Test Results to ASTM Specification C1107: 2001 Test Method Standard Result Flow Consistency ASTM C1437:2007 132% Setting Time ASTM C191:2008 Initial: Final: 5.4 hours 6.1 hours Plastic Volume Change ASTM C1090:2010 +0.57% Hardened Volume Change ASTM:C827:2010 1 day 3 days 14 days 28 days 56 days 0.68% 0.68% 0.68% 0.69% 0.67% Compressive Strength ASTM C109:2011b 1 day 3 days 7 days 28 days 27.9 MPa 46.4 MPa 50.1 MPa 57.6 MPa Note: All tests were carried out at 25oC ± 2oC until the age of the test. All above test results are independent third party results. Copies of these test results are available on request. The tests were carried out at a water addition rate of 4.4L per 20kg.
Technical Dayta Sheet Compedium
To see the actual publication please follow the link above