Page 467

32857 Parchem Technical Data Compendium 2015_Crop4emag.pdf

CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING JOINT FILLERS WATERPROOFING WATERSTOPS ROOFING TIMBER FLOORING ALPHABETICAL INDEX 455 Emer-Proof® Extended Wear Clear Coat Application Emer-Proof Extended Wear Clear Coat is applied to the cured Emer-Proof Top Coat by way of 6mm mohair roller sleeve or brush, in ‘thin’ coating applications. Application of 1-2 coats is recommended, dependant on likelihood and degree of potential stains and marks. Maintenence No special requirements, any damage identified during normal inspections should be repaired or replaced as appropriate. Limitations „ This product must be applied in ‘thin’ application coats. „ Not recommended over sand stone, limestone and similar surfaces. „ Do not apply coating when rain is forecast within the curing times. „ Not to be used for applications in immersed areas. „ Not to be used over wax residues, glass, fibreglass, chlorinated rubber, or epoxy coatings. „ Floor areas should have adequate falls. „ Base membrane must be thoroughly dry prior to Emer-Proof Extended Wear Clear Coat being applied. „ The Emer-Proof Top Coat should be left to dry for a minimum of 48 hours @ 23°C before the application of Emer-Proof Extended Wear Clear Coat takes place. Cleaning Water cleanup while in a wet state. Once dried removal by Solvent 10 or mechanical means. Drying times Tack free/re-coat time: 2-4 hours (will vary with surface porosity and temperatures experienced at time of application). Dry film: 8-12 hours; foot traffic – 24 hours: based on normal ambient conditions of 23°C. Allow a minimum further 24 hours of drying time @ 10°C. Please Note: Application of all liquid applied membranes and primers should always refer to the surface temperature conditions before commencing and not just ambient temperatures. (There are limitations to how hot/cold the surface temperature can be, when applying liquid based membrane or primer). For example: ambient temperatures may be 10°C but the substrate could be 0°C and have frost issues. The same applies with higher temperatures: ambient temperature may be 26°C but have a substrate temperature of 36°C. Supply 743119 Emer-Proof Extended Wear Clear Coat – 15L Pail (1L/8m²) 743118 Emer-Proof Top Coat (Grey) – 15L Pail Horizonal Application: (2 coats @ 1.5L per m² total) Vertical Application: (2 coats @ 1L per m² total) Shelf Life 12 months if kept in a cool, dry store. Storage Conditions Store in dry conditions at temperatures between 5°C and 30°C in the original, unopened containers. If stored at high temperatures, the shelf life may be reduced.


32857 Parchem Technical Data Compendium 2015_Crop4emag.pdf
To see the actual publication please follow the link above