CONTENTS CONCRETE REPAIR CORROSION CONTROL GROUTS & ANCHORS PROTECTIVE COATINGS INDUSTRIAL FLOORING SURFACE TREATMENTS JOINT SEALANTS CONCRETE JOINTING ROOFING WATERSTOPS WATERPROOFING JOINT FILLERS TIMBER FLOORING ALPHABETICAL Fosroc® Conbextra HES Properties Test Method Standard Result Compressive Strength AS 1478.2:2005 Consistency Water INDEX 124 Addition 2 hours 4 hours 8 hours 24 hours 28 days Plastic 2.0-2.3 30 35 40 42 58 Flowable 2.3-2.6 25 30 35 37 50 Bond Strength by Pull Off EN 1542:1999 2.6MPa Chloride ion Content EN 1015-17:2000 0.04% Fire Rating EN 13687-1:2002 Class A1 Non-Combustible Flexural Strength AS 1012.11 - 2000 1 Day (Modulus of Rupture) 7 Days 28 Days 3.0 MPa 4.5 MPa 6.5 MPa Indirect Tensile Strength AS 1012.10.2000 1 Day 7 Days 28 Days 1.5 MPa 2.5 MPa 3.0 MPa Setting Time AS 1012.18:1996 30-40 mins - initial set 50-50 mins - final set Fresh Wet Density 2200 kg/m³ - depending on consistency used Alkali reactive particles Rapid Mortar Bar Test (RTA T363) Non-reactive Flow Characteristics AS 1478.2:2005 350mm (Flow Trough) Minimum Thickness 15mm Maximum Thickness 150mm Clarification of property values: The typical properties given above are derived from laboratory testing. Compressive strengths stated above were measured using cube samples. Test results obtained will vary if carried out to an alternative standard or sample dimensions are used. Note: Compressive strengths stated were measured at bottom end water, eg., the 28 day strength of 50 MPa for flowable consistency was obtained at a water addition of 2.3 litres water per 20kg bag of Conbextra HES. Test Results to ASTM Specification C1107: 2001 Test Method Standard Result Flow Consistency ASTM C1437:2007 136% Setting Time ASTM C191:2008 Initial: Final: 30 minutes 65 minutes Plastic Volume Change ASTM C1090:2010 +0.38% Hardened Volume Change ASTM:C827:2010 1 day 3 days 14 days 28 days 56 days 0.007% 0.04% 0.03% 0.03% 0.03% Note: All tests were carried out at 25oC ± 2oC until the age of the test. All above test results are independent third party results. Copies of these test results are available on request. The tests were carried out at a water addition rate of 2.3L per 20kg.
32857 Parchem Technical Data Compendium 2015_Crop4emag.pdf
To see the actual publication please follow the link above